Host initdump (rust/uisim --bin initdump) showed mipidsi emits only SLPOUT,
MADCTL=0x48, INVON, COLMOD, NORON, DISPON — MADCTL already matches CircuitPython,
but the ST7796 extension setup (unlock, 0xB6 480-lines, power, gamma) is missing,
and sending it AFTER mipidsi's DISPON blanked the live panel. Replay the full
known-good st7796_init via Display::dcs() ending in its own DISPON. Adds the
initdump tool (capture init byte sequence on the host, no bench).
Co-Authored-By: Claude Opus 4.8 (1M context) <noreply@anthropic.com>
Answer to 'can you simulate it?': the UI now renders on the host.
- pm-ui: shared no_std embedded-graphics drawing (draw_ui), used by BOTH the
firmware and the simulator — single source, no divergence.
- uisim: host crate that draws pm-ui onto a framebuffer and exports a PNG (pure
Rust, no SDL). Confirmed the bring-up pattern renders correctly off-device, so
the black screen is a panel/controller issue, not a draw bug.
- pm-kit: use pm_ui::draw_ui; trim the ST7796 extension init to just unlock + 0xB6
(the gamma/VCOM sent after DISPON likely blanked it); LED solid during init then
slow 1 Hz blink so hung-init / running / reset-loop are distinguishable.
Note: the simulator covers WHAT we draw (layout/colour/logic). It does NOT model
the ST7796 controller's hardware quirks (0xB6 line count, MADCTL scan, SPI init) —
those still need the bench, but that's a one-time bring-up.
Co-Authored-By: Claude Opus 4.8 (1M context) <noreply@anthropic.com>
