Answer to 'can you simulate it?': the UI now renders on the host.
- pm-ui: shared no_std embedded-graphics drawing (draw_ui), used by BOTH the
firmware and the simulator — single source, no divergence.
- uisim: host crate that draws pm-ui onto a framebuffer and exports a PNG (pure
Rust, no SDL). Confirmed the bring-up pattern renders correctly off-device, so
the black screen is a panel/controller issue, not a draw bug.
- pm-kit: use pm_ui::draw_ui; trim the ST7796 extension init to just unlock + 0xB6
(the gamma/VCOM sent after DISPON likely blanked it); LED solid during init then
slow 1 Hz blink so hung-init / running / reset-loop are distinguishable.
Note: the simulator covers WHAT we draw (layout/colour/logic). It does NOT model
the ST7796 controller's hardware quirks (0xB6 line count, MADCTL scan, SPI init) —
those still need the bench, but that's a one-time bring-up.
Co-Authored-By: Claude Opus 4.8 (1M context) <noreply@anthropic.com>
Init the Kit's ST7796 320x480 over SPI0 (SCK=GP2, MOSI=GP3, CS=GP5, DC=GP6,
RST=GP7; BGR, colours inverted, 16 MHz) via mipidsi 0.9 + embedded-graphics, and
draw a panel + "PM-KIT / RUST OK" so SPI + the graphics stack are verifiable on
screen. GP25 LED keeps blinking as a heartbeat.
Compiles for thumbv8m; runtime (does it draw? colours/orientation right?) is the
on-device check. Next: tune orientation/colour if needed, then inputs + audio + pm-core.
Co-Authored-By: Claude Opus 4.8 (1M context) <noreply@anthropic.com>
First per-board binary. rust/pm-kit/ is a minimal rp235x-hal firmware that blinks
GP25 on the Pico 2 — proves the toolchain, RP2350 boot block (ImageDef), memory
layout, and flash before we add any drivers.
- src/main.rs + memory.x + build.rs + .cargo/config.toml: rp235x-hal blink, builds
for thumbv8m.main-none-eabihf.
- build.sh + uf2.py: one command builds the ELF in the container, objcopies to a raw
image, and packs pm-kit.uf2 (rp2350-arm-s family). Drag onto the Pico 2 in BOOTSEL.
Verified: builds clean; produces a valid 6-block UF2. Runtime (does it blink?) is the
on-device check. Next: drivers (display first) + link pm-core.
Co-Authored-By: Claude Opus 4.8 (1M context) <noreply@anthropic.com>
